These are some real problems experienced by ProDrive and Quantum hard drives in general that we see in our lab. We are not affiliated in any way with hard drive manufacturers. All the information below is based solely on our experience and we do not make any claims regarding reliability of the specific model. We see mostly failed drives in our lab and therefore we don't have complete statistics.
The drive is a Quantum(ProDrive) which was installed as a slave. This drive is used as my backup storage and is still visible in my BIOS. I wanted to restore a backup file, but it failed for some reason, it did not recognize the F: drive during the final installation. I ended up doing a clean install on drive C:, including reformatting, but when my new windows system booted, it did not recognize the F: drive.
Cleveland, Ohio, USA
Most common problem for Quantum drives is bad sectors. After some period of time magnetic media that covers the platters starts to degrade and magnetic domains can't be turned in a desired direction by writing element of the head. This is how bad sectors appear. When the drive starts reading data from such unreadable bad sector it could start freezing, scratching and sometimes even clicking: . This leads to further damage to the heads and surface, and may result in further data loss. As soon as you start experiencing such symptoms stop the drive immediately and send it to our data recovery lab for evaluation. Any further attempts would just add up to the problems. In our lab we use special imaging hardware tools that are capable of reading raw sector data ignoring checksum check. That's usually the only way to get as much data as possible from these LBAs.
Another quite common symptom Quantum drives have is clicking or knocking sound. The drive usually spins up, clicks a few times, spins faster, clicks again and spins down: . Most often this a sign of a bad head, but before doing any clean room work, it is very important to perform accurate diagnostics and eliminate a chance of possible firmware corruption that sometimes could also cause clicking.
The drive control chip is burnt out. I have no idea what else might be wrong with it. I took of the PCB and looked. It was fired like the picture on your website for my drive model. I tried a drive with the same models board, but it didn't work the control chip was different.
Quantum hard drives are also well-known for their firmware problems. If one of the firmware modules becomes corrupted, the drive fails to initialize correctly and stops working making the data inaccessible. In such case the drive is either
not found in BIOS at all
shows up with wrong S/N or capacity,
or fail to read any data or boot up operating system.
If you attempt to boot up from such drive or read any data from it you would get "Primary Master Hard Disk Fail" or "No operating system found" or "USB Device malfunctioned" error or something similar.
If you experience any of the symptoms described above with your Quantum ProDrive please feel free to contact us to get upfront quote on data recovery from your failed drive.
If you hear your Quantum hard drive making some other unusual noises visit our Hard Drive Sounds page for more examples.
We have seen a number of websites lately cloning information from our pages.
Stay away from those companies. They can steal information but they can't steal knowledge and experience.
Ottawa | Hull | Gatineau | Montreal | Toronto | Quebec | Vancouver | Calgary | Edmonton | Winnipeg | Hamilton
London | Kitchener | Halifax | Victoria | Windsor | Oshawa | Saskatoon | Sherbrooke | Kingston | Missisauga
Nepean | Barrie | Thunder Bay | Sudbury | Kanata | North Bay | BC | St. John's | Colchester| Newfoundland | PEI
Ontario | Quebec | Alberta | Saskatchewan | Manitoba | Alberta | British Columbia | Nova Scotia | New Brunswick